Crown CDi DriveCore 2x300-Watt Power Amplifier
The CDi DriveCore Series is an evolution in amplification, providing an impressive mix of high-performance; rich feature set, and competitive cost. Using technology derived from our flagship Installed Sound amplifier (Crown DriveCore Install series), the CDi DriveCore 2x300 offers streamlined functionality to work in almost any small/medium sized installation such as restaurants, retail stores, and more. Designed for ease-of-use in a variety of applications, the 2x300 is a 2-channel amp that includes network control/monitoring, high-level DSP, front-panel interface, and support for driving up to 100Vrms speaker loads without requiring a transformer. The entire CDi DriveCore line comes pre-loaded with JBL speaker tunings to help make installations quicker and easier.
DriveCore Technology - Crown’s technology eliminates hundreds of components within each amplifier
Network Control and Monitoring - Through Harman’s HiQnet Audio Architect software
DSP - On-board Digital Signal Processor
GPIO/AUX Port - Recall presets, mute channels, monitor faults, power on/off
Crown’s proprietary DriveCore technology eliminates hundreds of components within each amplifier, reducing the variability of component values, increasing reliability, resulting in incredible audio fidelity from an efficient design.
Network Control and Monitoring
Through Harman’s HiQnet Audio Architect software, the CDi DriveCore can be controlled, configured, and monitored through standard TCP/IQ network.
On-board Digital Signal Processor in each amplifier allows for custom configuration
Input Delay - Up to 1000ms
Input Parametric EQ - 8 band
Output Parametric EQ - 8 band
Output Delay - Up to 100ms
Direct Drive 70/100Vrms Output
Each output channel is capable of provide either 70V or 100V for high impedance applications.
Completely configure the amplifier using an intuitive front-panel interface.
Recall presets, mute channels, monitor faults, power on/off the amplifier, and more through a combined GPIO/AUX Port.
About the Manufacturer
Crown Audio is an industry leader in amplified sound. Crown makes amps for cinema venues, installed sites, touring rigs, portable PA and commercial audio. With over 67 years of focus on innovation and providing the best user experience, Crown Audio is continually raising the bar in audio amplification.
BLU Link: No
Sensitivity (for full rated power at 8 ohms): 0.7V RMS
Rated Power Output (per channel at 4 ohms): 300W
Analog Input Signal to Noise Ratio (ref. rated power, 100V, 20Hz - 20kHz) at 8 ohms): greater than 104dB
THD (full rated power, 20 Hz - 20 kHz): 0.35 percent
Damping Factor (20 Hz to 100 Hz): greater than 1000
Frequency Response (8 ohm, 20 Hz - 20 kHz): +/-0.5dB
Crosstalk (below rated power) 20 Hz to 1 kHz: greater than 80dB
Input Impedance (nominally balanced, nominally unbalanced): 20 k-ohm balanced, 10 k-ohm unblanced
Dimensions (inches) (W x H x D) (depth not including 1.3 inch front panel protrusion): 19 x 3.5 x 12.25
Weight: 14.56 lbs (6.6 kg)
Power Supply Connector: Standard IEC type 320 inlet for detachable connector 100 - 240V